![]() When the VPN Client uses OpenVPN, Router A can only implement this application scenario in Standalone mode. Note: When the VPN Client uses PPTP/L2TP, Router A can be implemented in both Controller mode and Standalone mode. The OpenVPN Client can access the server behind Router B through Site-to-Site VPN. The IP address of 192.168.0.10 is assigned from the server side.īy querying the routing table on the PC, it can be found that a route to 192.168.0.1/16 is generated, and the interface is the virtual IP address of OpenVPN. Import the OpenVPN configuration file into the OpenVPN GUI and connect. Here, we used the OpenVPN GUI on the PC to connect to the OpenVPN Server. This step is the same as the above process and will not be repeated here. For example, the range of 192.168.0.1/16 includes 192.168.0.1/24 and 192.168.20.1/24īecause the OpenVPN client will generate a new routing table based on the address range entered here after the connection is successfully established, it is necessary to ensure that the subnet of Router B is within this range before data can enter the OpenVPN Tunnel.Īt the same time, set the VPN IP Pool and the LAN IP of Router A in the same network segment.Īfter the OpenVPN Server is created, wait a few minutes and export the OpenVPN configuration file and sent to clients that need to connect. Please note that the IP address range entered in Local Network should include all the LAN IP address ranges of Router A and Router B. Go to VPN->OpenVPN->OpenVPN Server, create a new OpenVPN Server. The L2TP Client can access the server behind Router B through Site-to-Site VPN. Right-click the adapter –> Properties –> Networking, Double-click “Internet Protocol Version 4” –> Advanced, then you will find the Advanced TCP/IP settings for the VPN. Go to Control Panel –> Network and Internet –> Network and Sharing Center –> Change Adapter Settings, then you will find the L2TP VPN adapters. Note: “Use default gateway on remote network” is need to be enabled. The IP address of 192.168.0.2 is assigned from the server.įor a detailed configuration process, please refer to: How to configure PPTP/L2TP client on remote PC? Here, we used a PC connect to the L2TP Server. Here, we have established a VPN Tunnel between router A and router B. Create an IPsec Site-to-Site VPN between Router A and Router B.įor a detailed configuration process, please refer to How to Set up Site-to-Site Manual IPsec VPN Tunnels on Omada Gateway in Controller Mode? Note: The latest firmware of the router already supports VPN IP and LAN IP in the same network segment. Please note that the VPN IP Pool and the LAN IP of Router A need to be set in the same network segment, namely 192.168.0.1/24. Create an L2TP VPN Server on Router A.įor a detailed configuration process, please refer to: How to establish an L2TP Server by Omada Gateway in Standalone mode? The method of PPTP or L2TP configuration is similar, here L2TP is used as an example Now the VPN Client wants to access a Server inside Router B through two of these two VPN tunnels. ![]() ![]() Suppose a client is connected to Router A via VPN (PPTP/L2TP/OpenVPN), and Router A and Router B are connected via Site-to-Site VPN.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |